Show, Clear, Debug Commands
Page 1668 7750 SR OS Services Guide
Bridge Priority : 32768 Tx Hold Count : 6
Topology Change : Inactive Bridge Hello Time : 2
Last Top. Change : 0d 00:00:00 Bridge Max Age : 20
Top. Change Count : 0 Bridge Fwd Delay : 15
MST region revision: 0 Bridge max hops : 20
MST region name :
Root Bridge : N/A
Primary Bridge : N/A
Root Path Cost : 0 Root Forward Delay: 15
Rcvd Hello Time : 2 Root Max Age : 20
Root Priority : 32768 Root Port : N/A
-------------------------------------------------------------------------------
Spanning Tree Sap/Spoke SDP Specifics
-------------------------------------------------------------------------------
SAP Identifier : 1/1/12:2001.2001 Stp Admin State : Up
Port Role : N/A Port State : Unknown
Port Number : 2049 Port Priority : 128
Port Path Cost : 10 Auto Edge : Enabled
Admin Edge : Disabled Oper Edge : N/A
Link Type : Pt-pt BPDU Encap : Dot1d
Root Guard : Disabled Active Protocol : N/A
Last BPDU from : N/A
CIST Desig Bridge : N/A Designated Port : N/A
Forward transitions: 0 Bad BPDUs rcvd : 0
Cfg BPDUs rcvd : 0 Cfg BPDUs tx : 0
TCN BPDUs rcvd : 0 TCN BPDUs tx : 0
RST BPDUs rcvd : 0 RST BPDUs tx : 0
MST BPDUs rcvd : 0 MST BPDUs tx : 0
-------------------------------------------------------------------------------
Spanning Tree PIP (Provider Internal Port) Specifics
-------------------------------------------------------------------------------
Oper Status : Down mVPLS Prune State : N/A
Port Num : 2048 Oper Protocol : N/A
Port Role : N/A Port State : Discarding
CIST Desig Bridge : N/A Designated Port : N/A
b-Vpls STP state : Disabled
Forward transitions: 0 Bad BPDUs rcvd : 0
Cfg BPDUs rcvd : 0 Cfg BPDUs tx : 0
TCN BPDUs rcvd : 0 TCN BPDUs tx : 0
RST BPDUs rcvd : 0 RST BPDUs tx : 0
MST BPDUs rcvd : 0 MST BPDUs tx : 0
===============================================================================
*A:SetupCLI#
subscriber-hosts
Syntax subscriber-hosts [sap sap-id ] [ip ip-address[/mask]] [mac ieee-address] [sub-profile sub-
profile-name] [sla-profile sla-profile-name] [detail]
Context show>service>id
Description This command displays subscriber host information.
Parameters sap sap-id — Displays the specified subscriber host SAP information. See Common CLI Command
Descriptions on page 1933 for command syntax.