Show, Clear, Debug Commands
Page 1678 7750 SR OS Services Guide
port-db
Syntax port-db sap sap-id [detail]
port-db sap sap-id group grp-address
port-db sdp sdp-id:vc-id [detail]
port-db sdp sdp-id:vc-id group grp-address
Context show>service>id>igmp-snooping
Description This command displays information on the IGMP snooping port database for the VPLS service.
Parameters group grp-ip-address — Displays the IGMP snooping port database for a specific multicast group
address.
sap sap-id — Displays the IGMP snooping port database for a specific SAP. See Common CLI
Command Descriptions on page 1933 for command syntax.
sdp sdp-id — Displays only IGMP snooping entries associated with the specified mesh SDP or
spoke SDP. For a spoke SDP, the VC ID must be specified, for a mesh SDP, the VC ID is
optional.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID for which to display information.
Default For mesh SDPs only, all VC IDs.
Values 1 — 4294967295
group grp-address — Displays IGMP snooping statistics matching the specified group address.
source ip-address — Displays IGMP snooping statistics matching one particular source within the
multicast group.
Output Show Output — The following table describes the show output fields:
Label Description
Group Address
The IP multicast group address for which this entry contains infor-
mation.
Mode
Specifies the type of membership report(s) received on the interface
for the group.
In the include mode, reception of packets sent to the specified multi-
cast address is requested only from those IP source addresses listed
in the source-list parameter of the IGMP membership report.
In exclude' mode, reception of packets sent to the given multicast
address is requested from all IP source addresses except those listed
in the source-list parameter.
Type
Indicates how this group entry was learned.
If this group entry was learned by IGMP, the value is set to dynamic.
For statically configured groups, the value is set to static.
To Next Page
Loading...
