Alcatel-Lucent 7750 SR - Page 1707

VPLS Clear Commands
7750 SR OS Services Guide Page 1707
cem
Syntax cem
Context clear>service>id
Description This command clears CEM statistics for this service.
statistics
Syntax statistics
Context clear>service>stats
clear>service>id>authentication
Description This command clears session statistics for this service.
fdb
Syntax fdb {all | mac ieee-address | sap sap-id] | mesh-sdp sdp-id[:vc-id] | spoke-sdp sdp-id:vc-
id}
Context clear>service>id
Description This command clears FDB entries for the service.
Parameters all — Clears all FDB entries.
mac ieee-address — Clears only FDB entries in the FDB table with the specified 48-bit MAC
address. The MAC address can be expressed in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff
where aa, bb, cc, dd, ee and ff are hexadecimal numbers.
sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 1933 for command syntax.
mesh-sdp — Clears only service FDB entries associated with the specified mesh SDP ID. For a mesh
SDP, the VC ID is optional.
spoke-sdp — Clears only service FDB entries associated with the specified spoke SDP ID. For a
spoke SDP, the VC ID must be specified.
sdp-id — The SDP ID for which to clear associated FDB entries.
vc-id — The virtual circuit ID on the SDP ID for which to clear associated FDB entries.
Values sdp-id[:vc-id] sdp-id 1 — 17407
vc-id 1 — 4294967295
sdp-id:vc-id sdp-id 1 — 17407
vc-id 1 — 4294967295