Alcatel-Lucent 7750 SR - Page 1732

Show, Clear, Debug Commands
Page 1732 7750 SR OS Services Guide
Output Show Service Egress Command Output — The following table describes show service
egress label output fields.
Sample Output
*A:ALA-12# show service egress-label 0 10000
==============================================================================
Martini Service Labels
==============================================================================
Svc Id Sdp Id Type I.Lbl E.Lbl
------------------------------------------------------------------------------
1 10:1 Mesh 0 0
1 20:1 Mesh 0 0
1 30:1 Mesh 0 0
1 100:1 Mesh 0 0
...
1 107:1 Mesh 0 0
1 108:1 Mesh 0 0
1 300:1 Mesh 0 0
1 301:1 Mesh 0 0
1 302:1 Mesh 0 0
1 400:1 Mesh 0 0
100 300:100 Spok 0 0
200 301:200 Spok 0 0
300 302:300 Spok 0 0
400 400:400 Spok 0 0
------------------------------------------------------------------------------
Number of Bindings Found : 21
==============================================================================
*A:ALA-12#
ingress-label
Syntax ingress-label start-label [end-label]
Context show>service
Description This command displays services using the range of ingress labels. If only the mandatory start-label
Label Description
Svc Id
The value that identifies a service.
Sdp Id
The value that identifies a SDP.
Type
Indicates whether the SDP binding is a spoke or a mesh.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
E. Lbl
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
Number of bindings
found
The total number of SDP bindings that exist within the specified egress
label range.