Alcatel-Lucent 7750 SR - Page 174

Page 174 7750 SR OS Services Guide
ETH-CFM Configuration Commands
eth-cfm
Syntax
eth-cfm
Context config
Description This command enables the context to configure 802.1ag CFM parameters.
domain
Syntax domain md-index [format {dns | mac | none | string}] name md-name level level
domain md-index
no domain md-index
Context config>eth-cfm
Description This command configures Connectivity Fault Management domain parameters.
The no form of the command removes the MD index parameters from the configuration.
Parameters md-index — Specifies the Maintenance Domain (MD) index value.
Values 1 — 4294967295
format {dns | mac | string} — Specifies a value that represents the type (format).
Values dns: Specifies the DNS name format.
mac: X:X:X:X:X:X-u
X: [0..FF]h
u: [0..65535]d
none: The dot1ag MA is actually an Y.1731 MEG.
string Specifies an ASCII string.
Default string
name md-name — Specifies a generic Maintenance Domain (MD) name.
Values 1 — 43 characters
level level — Specifies the integer identifying the maintenance domain level (MD Level). Higher
numbers correspond to higher maintenance domains, those with the greatest physical reach, with
the highest values for customers' CFM packets. Lower numbers correspond to lower maintenance
domains, those with more limited physical reach, with the lowest values for single bridges or
physical links.
Values 0 — 7