Alcatel-Lucent 7750 SR - Page 176

Page 176 7750 SR OS Services Guide
mhf-creation
Syntax mhf-creation {none | explicit}
no mhf-creation
Context config>eth-cfm>domain>association>bridge-identifier
Description This command determines whether to allow automatic MIP creation for the MA.
Default none
Parameters none — Specifies that no MHFs can be created for this VID.
explicit — Specifies that MHFs can be created for this VID only on bridge ports through which this
VID can pass, and only if a MEP is created at some lower MA level. There must be at least one
lower level MEP provisioned on the same SAP or SDP.
vlan
Syntax vlan vlan-id
no vlan
Context config>eth-cfm>domain>association>bridge-identifier
Description This command configures the bridge-identifier primary VLAN ID. Note that it is informational only,
and no verification is done to ensure MEPs on this association are on the configured VLAN.
Parameters vlan-id — Specifies a VLAN ID monitored by MA.
Values 0 — 4094
ccm-interval
Syntax ccm-interval {10ms | 100ms | 1 | 10 | 60 | 600}
no ccm-interval
Context config>eth-cfm>domain>association
Description This command configures the CCM transmission interval for all MEPs in the association.
The no form of the command reverts the value to the default.
Default 10 seconds
Parameters interval — Specifies the interval between CCM transmissions to be used by all MEPs in the MA.
Values 10 milliseconds, 100 milliseconds, 1 second, 10 seconds, 60 seconds, 600 seconds
remote-mepid
Syntax [no] remote-mepid mep-id