Alcatel-Lucent 7750 SR - Page 1770

Show, Clear, Debug Commands
Page 1770 7750 SR OS Services Guide
Number of SDPs : 1
-------------------------------------------------------------------------------
* indicates that the corresponding row element may have been truncated.
-------------------------------------------------------------------------------
A:Dut-A#
subscriber-hosts
Syntax subscriber-hosts [sap sap-id] [ip ip-address[/mask]] [mac ieee-address] [sub-profile sub-
profile-name] [sla-profile sla-profile-name] [detail]
Context show>service>id
Description Displays subscriber host information.
Parameters sap sap-id — Displays the specified subscriber host SAP information. See Common CLI Command
Descriptions on page 1933 for command syntax.
ip-address/mask — The IP address of the IP interface. The ip-address portion of the address
command specifies the IP host address that will be used by the IP interface within the subnet.
This address must be unique within the subnet and specified in dotted decimal notation.
Values Allowed values are IP addresses in the range 1.0.0.0 – 223.255.255.255 (with
support of /31 subnets).
mask: 1 — 32
ieee-address — Specifies the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed values are
any non-broadcast, non-multicast MAC and non-IEEE reserved MAC addresses.
sub-profile sub-profile-name — Specifies an existing subscriber profile name to be associated with
the static subscriber host. The subscriber profile is configured in the config>subscr-mgmt>sub-
profile context.
sla-profile sla-profile-name — Specifies an existing SLA profile name to be associated with the
static subscriber host. The SLA profile is configured in the config>subscr-mgmt>sla-profile
context.
detail — Displays detailed information.
statistics
Syntax statistics [ip-int-name | ip-address]
Context show>router>dhcp
Description Display statistics for DHCP relay and DHCP snooping. If no IP address or interface name is
specified, then all configured interfaces are displayed. If an IP address or interface name is specified,
then only data regarding the specified interface is displayed.
Parameters ip-int-name | ip-address — Displays statistics for the specified IP interface.