Alcatel-Lucent 7750 SR - Page 1790

Show, Clear, Debug Commands
Page 1790 7750 SR OS Services Guide
If no optional parameters are specified, a summary SDP output for all SDPs is displayed.
Parameters sdp-id — The SDP ID for which to display information.
Default All SDPs.
Values 1 — 17407
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
Default SDPs with any far-end IP address.
detail — Displays detailed SDP information.
Default SDP summary output.
keep-alive-history — Displays the last fifty SDP keepalive events for the SDP.
Default SDP summary output.
Output Show Service SDP — The following table describes show service SDP output fields:
Label Description
SDP Id
The SDP identifier.
Adm MTU
Specifies the largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end router, without requiring the packet
to be fragmented.
Opr MTU
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring the
packet to be fragmented.
IP address
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Adm
Admin State
Specifies the state of the SDP.
Opr
Oper State
Specifies the operating state of the SDP.
Flags
Specifies all the conditions that affect the operating status of this SDP.
Signal
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Last Status Change
Specifies the time of the most recent operating status change to this
SDP.
Last Mgmt Change
Specifies the time of the most recent management-initiated change to
this SDP.
Number of SDPs
Specifies the total number of SDPs displayed according to the criteria
specified.
Hello Time
Specifies how often the SDP echo request messages are transmitted on
this SDP.