Alcatel-Lucent 7750 SR - Page 245

Virtual Leased Line Services
7750 SR OS Services Guide Page 245
Configuring Apipe SAP Parameters
Apipe SAP Use the following CLI syntax to configure Apipe SAP parameters.
CLI Syntax: config>service# apipe service-id [customer customer-id] [vpn
vpn-id] [vc-type {atm-vcc|atm-sdu|atm-vpc|atm-cell}][vc-switching]
sap sap-id
accounting-policy acct-policy-id
atm
egress
traffic-desc traffic-desc-profile-id
ingress
traffic-desc traffic-desc-profile-id
oam
alarm-cells
terminate
collect-stats
description description-string
egress
qos policy-id
scheduler-policy scheduler-policy-name
ingress
qos policy-id [shared-queuing]
scheduler-policy scheduler-policy-name
multi-service-site customer-site-name
no shutdown
The following example displays the command usage to create Apipe SAPs:
PE router 1 (A:ALA-41):
Example: A:ALA-41>config>service# apipe 5
A:ALA-41>config>service>apipe# sap 1/1/1:0/32 create
A:ALA-41>config>service>apipe>sap# ingress
A:ALA-41>config>service>apipe>sap>ingress# qos 102
A:ALA-41>config>service>apipe>sap>ingress# exit
A:ALA-41>config>service>apipe>sap# egress
A:ALA-41>config>service>apipe>sap>egress# qos 103
A:ALA-41>config>service>apipe>sap>egress# exit
A:ALA-41>config>service>apipe>sap# no shutdown
A:ALA-41>config>service>apipe>sap# exit
A:ALA-41>config>service>apipe#
PE router 2 (A:ALA-42):
Example: A:ALA-42>config>service# apipe 5
A:ALA-42>config>service>apipe# sap 2/2/2:0/32 create
A:ALA-42>config>service>apipe>sap# ingress
A:ALA-42>config>service>apipe>sap>ingress# qos 102