Virtual Leased Line Services
7750 SR OS Services Guide Page 323
VLL Global Commands
apipe
Syntax apipe service-id [customer customer-id] [vpn vpn-id] [vc-type {atm-vcc | atm-sdu | atm-
vpc | atm-cell}] [vc-switching]
no apipe service-id
Context config>service
Description The Apipe service provides a point-to-point Layer 2 VPN connection to a remote SAP or to another
local SAP. An Apipe can connect an ATM or Frame Relay endpoint either locally or over a PSN to a
remote endpoint of the same type or of a different type and perform interworking between the two
access technologies.
Parameters service-id — The unique service identification number or string identifying the service in the service
domain. This ID must be unique to this service and may not be used for any other service of any
type. The service-id must be the same number used for every 7750 SR, 7450 ESS and 7710 SR
on which this service is defined.
Values service-id: 1 — 2147483648
svc-name: 64 characters maximum
custom er
customer customer-id — Specifies the customer ID number to be associated with the service. This
parameter is required on service creation and optional for service editing or deleting.
Values 1 — 2147483647
vpn vpn-id — Specifies the VPN ID number which allows you to identify virtual private networks
(VPNs) by a VPN identification number.
vpn-id
Values 1 — 2147483647
Default null (0)
vc-type — Specifies a 15 bit value that defines the type of the VC signaled to the peer. Its values are
defined in draft-ietf-pwe3-iana-allocation and it defines both the signaled VC type as well as the
resulting datapath encapsulation over the Apipe.
vc-type
Values atm-vcc, atm-sdu, atm-vpc, atm-cell
Default atm-sdu
vc-switching — Specifies if the pseudowire switching signalling is used for the spoke SDPs
configured in this service.
To Next Page
Loading...
