Alcatel-Lucent 7750 SR - Page 343

Virtual Leased Line Services
7750 SR OS Services Guide Page 343
Circuit Emulation Commands
cem
Syntax cem
Context config>service>cpipe>sap
config>service>epipe>sap
Description This command enables the context to specify circuit emulation (CEM) properties.
local-ecid
Syntax local-ecid emulated circuit identifier
no local-ecid
Context config>service>epipe>sap>cem
Description This command defines the Emulated Circuit Identifiers (ECID) to be used for the local (source) end
of the circuit emulation service.
The no form of the command removes the ECID from the configuration.
Default 65535
Parameters emulated circuit identifier — Specifies the value to be used as the local (source) ECID for the circuit
emulation service. On CES packet reception, the ECID in the packet will be compared to the
configured local-ecid value. These must match for the packet payload to be used for the TDM
circuit. The remote-ecid value is inserted into the MEF-8 CES packet to be transmitted.
Values 0 — 1048575
packet
Syntax packet jitter-buffer milliseconds [payload-size bytes]
packet payload-size bytes
no packet bytes
Context config>service>cpipe>sap
config>service>epipe>sap>cem
Description This command specifies the jitter buffer size, in milliseconds, and payload size, in bytes.
Default
The default value depends on the CEM SAP endpoint type, and if applicable, the number of timeslots: