Alcatel-Lucent 7750 SR - Page 351

Virtual Leased Line Services
7750 SR OS Services Guide Page 351
test-pattern
Syntax test-pattern {all-zeros | all-ones} [crc-enable]
no test-pattern
Context config>service>epipe>spoke-sdp>eth-cfm>mep
config>service>epipe>sap>eth-cfm>mep
Description This command configures the test pattern for eth-test frames.
The no form of the command removes the values from the configuration.
Parameters all-zeros — Specifies to use all zeros in the test pattern.
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
Default all-zeros
fault-propagation-enable
Syntax fault-propagation-enable {use-if-tlv | suspend-ccm}
no fault-propagation-enable
Context config>service>epipe>sap>eth-cfm>mep
config>service>epipe>spoke-sdp>eth-cfm>mep
config>service>ipipe>sap>eth-cfm>mep
Description This command configures the fault propagation for the MEP.
Parameters use-if-tlv — Specifies to use the interface TLV.
suspend-ccm — Specifies to suspend the continuity check messages.
low-priority-defect
Syntax low-priority-defect {allDef | macRemErrXcon | remErrXcon | errXcon | xcon | noXcon}
Context config>service>epipe>spoke-sdp>eth-cfm>mep
config>service>epipe>sap>eth-cfm>mep
Description This command specifies the lowest priority defect that is allowed to generate a fault alarm.
Default remErrXcon
Values allDef DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM,
and DefXconCCM
macRemErrXconOnly DefMACstatus, DefRemoteCCM, DefErrorCCM, and
DefXconCCM
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon Only DefErrorCCM and DefXconCCM