Virtual Leased Line Services
7750 SR OS Services Guide Page 381
Parameters sdp-id — The SDP identifier. Allowed values are integers in the range of 1 to 17407 for existing
SDPs.
vc-id — The virtual circuit identifier.
Values 1 — 4294967295
no endpoint — Adds or removes a spoke SDP association.
endpoint endpoint-name — Specifies the name of the service endpoint.
icb — Configures the spoke SDP as an inter-chassis backup SDP binding.
cell-concatenation
Syntax cell-concatenation
Context config>service>apipe>spoke-sdp
Description This command enables the context to provide access to the various options that control the
termination of ATM cell concatenation into an MPLS frame. Several options can be configured
simultaneously. The concatenation process for a given MPLS packet ends when the first
concatenation termination condition is met. The concatenation parameters apply only to ATM N:1
cell mode VLL.
aal5-frame-aware
Syntax [no] aal5-frame-aware
Context config>service>apipe>spoke-sdp>cell-concat
Description This command enables the configuration of AAL5 end-of-message (EOM) to be an indication to
complete the cell concatenation operation.
The no form of the command resets the configuration to ignore the AAL5 EOM as an indication to
complete the cell concatenation.
clp-change
Syntax [no] clp-change
Context config>service>apipe>spoke-sdp>cell-concat
Description This command enables the configuration of CLP change to be an indication to complete the cell
concatenation operation.
The no form of the command resets the configuration to ignore the CLP change as an indication to
complete the cell concatenation.
To Next Page
Loading...
