Virtual Leased Line Services
7750 SR OS Services Guide Page 385
filter
Syntax filter [ip ip-filter-id]
no filter
Context config>service>fpipe>spoke-sdp>egress
config>service>fpipe>spoke-sdp>ingress
Description This command associates an IP filter policy with an ingress or egress Service Distribution Point
(SDP). Filter policies control the forwarding and dropping of packets based on IP matching criteria.
Only one filter can be applied to a spoke SDP at a time.
The filter command is used to associate a filter policy with a specified ip-filter-id with an ingress or
egress spoke SDP. The ip-filter-id must already be defined before the filter command is executed. If
the filter policy does not exist, the operation will fail and an error message returned.
IP filters apply only to RFC 2427-routed IP packets. Frames that do not contain IP packets will not be
subject to the filter and will always be passed, even if the filter's default action is to drop.
The no form of this command removes any configured filter ID association with the SDP. The filter
ID itself is not removed from the system unless the scope of the created filter is set to local. To avoid
deletion of the filter ID and only break the association with the service object, use the scope
command within the filter definition to change the scope to local or global. The default scope of a
filter is local.
Parameters ip — Keyword indicating the filter policy is an IP filter.
ip-filter-id — The filter name acts as the ID for the IP filter policy. The filter ID must already exist
within the created IP filters.
Values 1 — 65535
vc-label
Syntax [no] vc-label vc-label
Context config>service>fpipe>spoke-sdp>egress
config>service>apipe>spoke-sdp>egress
config>service>cpipe>spoke-sdp>egress
config>service>ipipe>spoke-sdp>egress
Description This command configures the egress VC label.
Parameters vc-label — A VC egress value that indicates a specific connection.
Values 16 — 1048575
To Next Page
Loading...
