VLL Service Configuration Commands
Page 402 7750 SR OS Services Guide
shared-queuing — This keyword can only be specified on SAP ingress. The shared-queueing
keyword specifies the shared queue policy will be used by this SAP. When the value of this
object is null, the SAP will use individual ingress QoS queues, instead of the shared ones.
queue-override
Syntax [no] queue-override
Context config>service>cpipe>sap>egress
config>service>cpipe>sap>ingress
Description This command enables the context to configure override values for the specified SAP egress or
ingress QoS queue. These values override the corresponding ones specified in the associated SAP
egress or ingress QoS policy. If the policy was created as a template policy, this command overrides
the parameter and its description and queue parameters in the policy.
queue
Syntax [no] queue queue-id [create]
Context config>service>cpipe>sap>egress>queue-override
config>service>cpipe>sap>ingress>queue-override
Description This command specifies the ID of the queue whose parameters are to be overridden.
Parameters queue-id — The queue ID whose parameters are to be overridden.
create — Keyword used to create the queue. The create keyword requirement can be enabled/
disabled in the environment>create context.
adaptation-rule
Syntax adaptation-rule [pir adaptation-rule}] [cir adaptation-rule}]
Context config>service>cpipe>sap>egress>queue-override>queue
config>service>cpipe>sap>ingress>queue-override>queue
Description This command can be used to override specific attributes of the specified queue’s adaptation rule
parameters. The adaptation rule controls the method used by the system to derive the operational CIR
and PIR settings when the queue is provisioned in hardware. For the CIR and PIR parameters individ-
ually, the system attempts to find the best operational rate depending on the defined constraint.
Default no adaptation-rule
Parameters pir — The pir parameter defines the constraints enforced when adapting the PIR rate defined within
the queue queue-id rate command. The pir parameter requires a qualifier that defines the
constraint used when deriving the operational PIR for the queue. When the rate command is not
specified, the default applies.
To Next Page
Loading...
