Virtual Leased Line Services
7750 SR OS Services Guide Page 413
If the service MTU is larger than the path MTU minus control word length (if applicable), the SDP
binding for the service will be placed in an inoperative state with sdp-bind oper flag
PathMTUTooSmall.
If the CEM SAP’s packet size is larger than the service MTU then the service will be placed in an
inoperative state with service oper flag ServiceMTUTooSmall . The CEM SAP packet size is defined
as CEM SAP payload-size plus rtp-header size (if applicable).
In the event that a service MTU, port or channel MTU, or path MTU is dynamically or
administratively modified, then all associated SAP and SDP binding operational states are
automatically re-evaluated.
The no form of this command returns the default service-mtu for the indicated service type to the
default value.
Default cpipe: 1514
octets — The size of the MTU in octets, expressed as a decimal integer, between 1 — 9194.
service-name
Syntax service-name service-name
no service-name
Context config>service>cpipe
Description This command configures an optional service name, up to 64 characters in length, which adds a name
identifier to a given service to then use that service name in configuration references as well as
display and use service names in show commands throughout the system. This helps the service
provider/administrator to identify and manage services within the 7750 SR and 7710 SR platforms.
All services are required to assign a service ID to initially create a service. However, either the service
ID or the service name can be used o identify and reference a given service once it is initially created.
Parameters service-name — Specifies a unique service name to identify the service. Service names may not begin
with an integer (0-9).
To Next Page
Loading...
