Alcatel-Lucent 7750 SR - Page 526

Page 526 7750 SR OS Services Guide
Distributed VPLS SAPs
To configure a distributed VPLS service, you must configure service entities on originating and
far-end nodes. You must use the same service ID on all ends (for example, create a VPLS service
ID 9000 on ALA-1, ALA-2, and ALA-3). A distributed VPLS consists of a SAP on each
participating node and an SDP bound to each participating node.
For SDP configuration information, see Configuring an SDP on page 94. For SDP binding
information, see Configuring SDP Bindings on page 540.
The following example displays a configuration of VPLS SAPs configured for ALA-1, ALA-2,
and ALA-3.
*A:ALA-1>config>service# info
--------------------------------------------
...
vpls 9000 customer 6 vpn 750 create
description "Distributed VPLS services."
def-mesh-vc-id 750
stp
shutdown
exit
sap 1/2/5:0 create
description "VPLS SAP"
multi-service-site "West"
exit
exit
...
--------------------------------------------
*A:ALA-1>config>service#
*A:ALA-2>config>service# info
--------------------------------------------
...
vpls 9000 customer 6 vpn 750 create
description "Distributed VPLS services."
def-mesh-vc-id 750
stp
shutdown
exit
sap 1/1/2:22 create
description "VPLS SAP"
multi-service-site "West"
exit
exit
...
--------------------------------------------
*A:ALA-2>config>service#
*A:ALA-3>config>service# info
----------------------------------------------
...
vpls 9000 customer 6 vpn 750 create
description "Distributed VPLS services."
def-mesh-vc-id 750