Virtual Private LAN Services
Page 680 7750 SR OS Services Guide
errXcon Only DefErrorCCM and DefXconCCM
xcon Only DefXconCCM; or
noXcon No defects DefXcon or lower are to be reported
mac-address
Syntax mac-address mac-address
no mac-address
Context config>service>vpls>eth-cfm>mep
config>service>vpls>>spoke-sdp>eth-cfm>mep
config>service>vpls>mesh-sdp>eth-cfm>mep
config>service>vpls>sap>eth-cfm>mep
Description This command specifies the MAC address of the MEP.
The no form of this command reverts the MAC address of the MEP back to that of the port (if the
MEP is on a SAP) or the bridge (if the MEP is on a spoke).
Parameters mac-address — Specifies the MAC address of the MEP.
Values 6-byte mac-address in the form of xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx of the
MEP. Must be unicast. Using the all zeros address is equivalent to the no form of
this command.
one-way-delay-threshold
Syntax one-way-delay-threshold seconds
Context config>service>vpls>sap>eth-cfm>mep
Description This command enables/disables eth-test functionality on MEP.
Parameters seconds — Specifies the one way delay threshold, in seconds.
Values 0..600
Default 3
limit-mac-move
Syntax limit-mac-move [blockable | non-blockable]
no limit-mac-move
Context config>service>vpls>spoke-sdp
config>service>vpls>sap
Description This command indicates whether or not the mac-move agent, when enabled using
config>service>vpls>mac-move or config>service>epipe>mac-move, will limit the MAC re-learn
(move) rate on this SAP.
To Next Page
Loading...
