Virtual Private LAN Services
Page 684 7750 SR OS Services Guide
Values Any valid customer-site-name created within the context of the customer-id.
precedence
Syntax precedence [precedence-value | primary]
no precedence
Context config>service>vpls>spoke-sdp
Description This command configures the precedence of this SDP bind when there are multiple SDP binds
attached to one service endpoint. When an SDP bind goes down, the next highest precedence SDP
bind begins forwarding traffic.
Parameters precendence-value — Specifies the precedence of this SDP bind.
Values 1 — 4
primary — Assigns this as the primary spoke-sdp.
static-mac
Syntax [no] static-mac ieee-mac-address [create]
Context config>service>vpls>sap
config>service>vpls>mesh-sdp
config>service>vpls>spoke-sdp
Description This command creates a local static MAC entry in the Virtual Private LAN Service (VPLS)
forwarding database (FDB) associated with the Service Access Point (SAP).
In a VPLS service, MAC addresses are associated with a Service Access Point (SAP) or with a
Service Distribution Point (SDP). MACs associated with a SAP are classified as local MACs, and
MACs associated with an SDP are remote MACs.
Local static MAC entries create a permanent MAC address to SAP association in the forwarding
database for the VPLS instance so that MAC address will not be learned on the edge device.
Note that static MAC defnitions on one edge device are not propagated to other edge devices
participating in the VPLS instance, that is, each edge device has an independent forwarding database
for the VPLS.
Only one static MAC entry (local or remote) can be defined per MAC address per VPLS instance.
By default, no static MAC address entries are defined for the SAP.
The no form of this command deletes the static MAC entry with the specified MAC address
associated with the SAP from the VPLS forwarding database.
Parameters ieee-mac-address — Specifies the 48-bit MAC address for the static ARP in the form
aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee and ff are hexadecimal numbers.
Allowed values are any non-broadcast, non-multicast MAC and non-IEEE reserved MAC
addresses.
create — This keyword is mandatory when specifying a static MAC address.
To Next Page
Loading...
