Virtual Private LAN Services
Page 706 7750 SR OS Services Guide
no scheduler-policy
Context config>service>vpls>sap>ingress
config>service>vpls>sap>egress
Description This command applies an existing scheduler policy to an ingress or egress scheduler used by SAP
queues associated with this multi-service customer site. The schedulers defined in the scheduler
policy can only be created once the customer site has been appropriately assigned to a chassis port,
channel or slot. Scheduler policies are defined in the config>qos>scheduler-policy scheduler-policy-
name context.
The no form of this command removes the configured ingress or egress scheduler policy from the
multi-service customer site. When the policy is removed, the schedulers created due to the policy are
removed also making them unavailable for the ingress SAP queues associated with the customer site.
Queues that lose their parent scheduler association are deemed to be orphaned and are no longer
subject to a virtual scheduler. The SAPs that have ingress queues reliant on the removed schedulers
enter into an operational state depicting the orphaned status of one or more queues. When the no
scheduler-policy command is executed, the customer site ingress or egress node will not contain an
applied scheduler policy.
scheduler-policy-name: — The scheduler-policy-name parameter applies an existing scheduler policy
that was created in the config>qos>scheduler-policy scheduler-policy-name context to create
the hierarchy of ingress or egress virtual schedulers. The scheduler names defined within the
policy are created and made available to any ingress or egress queues created on associated
SAPs.
Values Any existing valid scheduler policy name.
vlan-translation
Syntax vlan-translation {vlan-id | copy-outer}
no vlan-translation
Context cconfig>service>vpls>sap>ingress
Description This command configures ingress VLAN translation. If enabled with an explicit VLAN value, the
preserved VLAN ID will be overwritten with this value. This setting is applicable to Dot1q-
encapsulated ports. If enabled with the copy-outer keyword, the outer VLAN ID will be copied to the
inner position on QinQ-encapsulated ports. The feature is not supported on default-dot1q SAPs (1/1/
1:* and 1/1/1:0), as well as on TopQ SAPs.
The no form of this command sets the default value, and no action will be taken.
Default per default the preserved VLAN values will not be overwritten
Parameters vlan-id — Specifies the to use the VLAN ID of the SAP.
Values 0 — 4094
copy-outer — Specifies that the outer VLAN ID will be copied to the inner position on QinQ-
encapsulated ports
To Next Page
Loading...
