Virtual Private LAN Services
Page 724 7750 SR OS Services Guide
config>service>vpls>spoke-sdp>snooping>static
config>service>vpls>mesh-sdp>snooping>static
Description This command adds a static multicast group either as a (*, g) or as one or more (s,g) records. When a
static IGMP group is added, multicast data for that (*,g) or (s,g) is forwarded to the specific SAP or
SDP without receiving any membership report from a host.
Default none
Parameters grp-address — Specifies an IGMP multicast group address that receives data on an interface. The IP
address must be unique for each static group.
group-policy
Syntax group-policy policy-name
no group-policy
Context config>service>vpls>sap>igmp-snooping>mvr
config>service>vpls>mld-snooping>mvr
Description This command identifies filter policy of multicast groups to be applied to this VPLS entity. The
sources of the multicast traffic must be a member of the VPLS.
The no form of the command removes the policy association from the VPLS configuration.
Default No group policy is specified.
Parameters policy-name — The group policy name. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes. Routing policies are
configured in the config>router>policy-options context. The router policy must be defined before
it can be imported. For details on IGMP policies, please see section “Enabling IGMP group
membership report filtering” in the 7750 SR OS Router Configuration Guide.
fault-propagation-bmac
Syntax fault-propagation-bmac [mac-name | ieee-address] [create]
no fault-propagation-bmac [mac-name | ieee-address]
Context config>service>vpls>mesh-sdp
config>service>vpls>sap
config>service>vpls>spoke-sdp
Description This command configures associated BMAC addresses for fault propagation on a B-VPLS SAP or
SDP binding. The statement can appear up to four times in the configuration to support four remote
BMAC addresses in the same remote B-VPLS. The configured VPLS must be a B-VPLS.
The no form of the command removes the specified MAC name or MAC address from the list of
Fault Propagation BMAC addresses associated with the SAP (or SDP).
Parameters mac-name — Specifies a (predefined) MAC name to associate with the SAP or SDP, indirectly
specifying a Fault Propagation BMAC address. Up to 32 characters in length.
To Next Page
Loading...
