Virtual Private LAN Services
7750 SR OS Services Guide Page 731
Default not enabled
max-num-groups
Syntax max-num-groups count
no max-num-groups
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>mesh-sdp>snooping
config>service>vpls>sap>mld-snooping
config>service>vpls>spoke-sdp>mld-snooping
config>service>vpls>mesh-sdp>mld-snooping
Description This command defines the maximum number of multicast groups that can be joined on this SAP or
SDP. If the node receives an IGMP join message that would exceed the configured number of groups,
the request is ignored.
Default no max-num-groups
Parameters count — Specifies the maximum number of groups that can be joined on this SAP or SDP.
Values 1 — 1000
max-num-sources
Syntax max-num-sources max-num-sources
no max-num-sources
Context config>service>vpls>sap>igmp-snooping
Description This command configures the maximum number of multicast sources allowed per group.
Parameters max-num-sources — Specifies the maximum number of multicast sources allowed per group.
Values 1 — 1000
mrouter-port
Syntax [no] mrouter-port
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>mesh-sdp>snooping
Description This command specifies whether a multicast router is attached behind this SAP or SDP.
Configuring a SAP as an mrouter-port will have a double effect. Firstly, all multicast traffic received
on another SAP or SDP will be copied to this SAP or SDP. Secondly, IGMP reports generated by the
system as a result of someone joining or leaving a multicast group, will be sent to this SAP or SDP.
To Next Page
Loading...
