Virtual Private LAN Services
7750 SR OS Services Guide Page 737
Description This command controls the frequency with which the LeaveAll state machine generates LeaveAll
PDUs. The timer is required on a per-Port, per-MRP Participant basis. The Leave All Period Timer is
set to a random value, T, in the range LeaveAllTime<T<1.5*leave-all-time when it is started. Refer to
IEEE 802.1ak-2007 section 10.7.4.3.
Default 100
Parameters value — [60-300] tenths of a second
mrp-policy
Syntax [no] mrp-policy policy-name
Context config>service>vpls>sap>mrp
config>service>vpls>spoke-sd>mrp
config>service>vpls>mesh-sdp>mrp
Description This command instructs MMRP to use the mrp-policy specified in the command to control which
Group BMAC attributes will be declared and registered on the egress SAP/Mesh-SDP/Spoke-SDP.
The Group BMACs will be derived from the ISIDs using the procedure used in the PBB solution. The
Group MAC = standard OUI with the last 24 bits being the ISID value. If the policy-name refers to a
non-existing mrp-policy the command should return error. Changes to a mrp-policy are aloowed and
applied to the SAP/SDPs under which the policy is referenced.
Default no mrp-policy is defined
Parameters policy-name — Specifies the redirect policy name. Allowed values are any string up to 32 characters
long composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
periodic-time
Syntax [no] periodic-time value
Context config>service>vpls>sap>mrp
config>service>vpls>spoke-sdp>mrp
config>service>vpls>mesh-sdp>mrp
Description This command controls the frequency the PeriodicTramsmission state machine generates periodic
events if the Periodic Transmission Timer is enabled. The timer is required on a per-Port basis. The
Periodic Transmissing Timer is set to one second when it is started.
Default 10
Parameters value — [10-100] tenths of a second
To Next Page
Loading...
