Virtual Private LAN Services
7750 SR OS Services Guide Page 741
Default no send-queries
source
Syntax [no] source ip-address
Context config>service>vpls>sap>igmp-snooping>static>group
config>service>vpls>spoke-sdp>snooping>static>group
config>service>vpls>mesh-sdp>snooping>static>group
Description This command adds a static (s,g) entry to allow multicast traffic for the corresponding multicast
group from that specific source. For the same multicast group, more than one source can be specified.
Static (s,g) entries can not be entered when a starg is already created.
The no form of the command removes the source from the configuration.
Default none
Parameters ip-address — Specifies the IPv4 unicast address.
starg
Syntax [no] starg
Context config>service>vpls>sap>igmp-snooping>static>group
config>service>vpls>spoke-sdp>snooping>static>group
config>service>vpls>mesh-sdp>snooping>static>group
Description This command adds a static (*,g) entry to allow multicast traffic for the corresponding multicast
group from any source. This command can only be enabled if no existing source addresses for this
group are specified.
The no form of the command removes the starg entry from the configuration.
Default no starg
static
Syntax static
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>mesh-sdp>snooping
config>service>vpls>sap>mld-snooping
config>service>vpls>spoke-sdp>mld-snooping
config>service>vpls>mesh-sdp>mld-snooping
Description This command enables access to the context to configure static group addresses. Static group
addresses can be configured on a SAP or SDP. When present either as a (*, g) or a (s,g) entry,
To Next Page
Loading...
