IES Service Configuration Commands
7750 SR OS Services Guide Page 941
gw-ip-address ip-address — Specifies a separate IP address within the subnet for SRRP routing
purposes. This parameter must be followed by a valid IP interface that exists within the
subscriber subnet created by the address command. The defined gateway IP address cannot
currently exist as a subscriber host (static or dynamic). If the defined ip-address already exists as
a subscriber host address, the address command will fail. The specified ip-address must be
unique within the system.
The gw-address parameter may be specified at anytime. If the subscriber subnet was created
previously, executing the address command with a gw-address parameter will simply add the
SRRP gateway IP address to the existing subnet.
If the address command is executed without the gw-address parameter when the subscriber
subnet is associated with an active SRRP instance, the address will fail. If the SRRP instance is
inactive or removed, executing the address command without the gw-address parameter will
remove the SRRP gateway IP address from the specified subscriber subnet.
If the address command is executed with a new gw-address, all SRRP instances currently
associated with the specified subscriber subnet will be updated with the new SRRP gateway IP
address.
delayed-enable
Syntax delayed-enable seconds [init-only]
no delayed-enable
Context config>service>ies>sub-if
Description This command delays making interface operational by the specified number of seconds.
In environments with many subscribers, it can take time to synchronize the subscriber state between
peers when the subscriber-interface is enabled (perhaps, after a reboot). To ensure that the state has
time to be synchronized, the delayed-enable timer can be specified. The optional parameter init-only
can be added to use this timer only after a reboot.
Default no delayed-enable
Parameters seconds — Specifies the number of seconds to delay before the interface is operational.
Values 1 — 1200
init-only — Delays the initialization of the subscriber-interface to give the rest of the system time to
complete necessary tasks such as allowing routing protocols to converge and/or to allow MCS to
sync the subscriber information. The delay only occurs immediately after a reboot.
oper-up-while-empty
Syntax [no] oper-up-while-empty
Context config>service>ies>sub-if>grp-if
Description This command allows the subscriber interface to treat this group interface to be operationally enabled
without any active SAPs.
To Next Page
Loading...
