Alcatel-Lucent 7750 SR - Page 945

IES Service Configuration Commands
7750 SR OS Services Guide Page 945
Default no bfd
Parameters transmit-interval — Sets the transmit interval for the BFD session.
Values 100 — 100000
10 — 100000 (see Important Notes above)
Default 100
receive receive-interval — Sets the receive interval for the BFD session.
Values 100 — 100000
10 — 100000 (see Important Notes above)
Default 100
multiplier multiplier — Set the multiplier for the BFD session.
Values 3— 20
Default 3
echo-receive echo-interval — Sets the minimum echo receive interval, in milliseconds, for the BFD
session.
Values 100 — 100000
10 — 100000 (see Important Notes above)
Default 100
type cpm-np — Specifies that the type is cpm-np.
cflowd
Syntax cflowd {acl | interface}
no cflowd
Context config>service>ies>interface
Description This command enables cflowd to collect traffic flow samples through a router for analysis.
cflowd is used for network planning and traffic engineering, capacity planning, security, application
and user profiling, performance monitoring, usage-based billing, and SLA measurement. When
cflowd is enabled at the interface level, all packets forwarded by the interface are subjected to
analysis according to the cflowd configuration.
Default no cflowd
Parameters ACL — cflowd configuration associated with a filter.
interface — cflowd configuration associated with an IP interface.