IES Interface Commands
Page 964 7750 SR OS Services Guide
ete-fragment-threshold
Syntax ete-fragment-threshold fragment-threshold
no ete-fragment-threshold
Context config>service>ies>interface>sap>frame-relay>frf.12
config>service>vprn>interface>sap>frame-relay>frf.12
config>service>epipe>sap>frame-relay>frf.12
config>service>ipipe>sap>frame-relay>frf.12
config>service>vpls>sap>frame-relay>frf.12
Description This command sets the maximum length, in bytes, of a fragment transmitted across a Frame Relay
SAP with the FRF.12 end-to-end fragmentation enabled.
The no form of this command resets the fragment threshold back to the default value.
Default 128
Parameters fragment-threshold — Specifies the maximum fragment length, in bytes, to be transmitted across the
FR SAP.
Values 128 — 512 bytes
interleave
Syntax interleave
no interleave
Context config>service>ies>interface>sap>frame-relay>frf.12
Description This command enables interleaving of high priority frames and low-priority frame fragments within a
FR SAP using FRF.12 end-to-end fragmentation.
When this option is enabled, only frames of the FR SAP non expedited forwarding class queues are
subject to fragmentation. The frames of the FR SAP expedited queues are interleaved, with no
fragmentation header, among the fragmented frames. In effect, this provides a behavior like in
MLPPP Link Fragment Interleaving (LFI).
When this option is disabled, frames of all the FR SAP forwarding class queues are subject to
fragmentation. The fragmentation header is however not included when the frame size is smaller than
the user configured fragmentation size. In this mode, the SAP transmits all fragments of a frame
before sending the next full or fragmented frame.
The receive direction of the FR SAP supports both modes of operation concurrently, with and without
fragment interleaving.
The no form of this command restores the default mode of operation.
Default no interleave
To Next Page
Loading...
