Allen-Bradley ControlLogix User Manual

1756-6.5.3 - December 1999
8-18 PLC-5C to Logix5550 Controller: Scheduled Communications
Create the Producer
Application
Perform the following steps to create the PLC-5C producer application:
1. Start the RSLogix5 software.
2. From the File menu, select New. The Select Processor Type window will
appear.
3. Enter the following information and click on OK.
You will receive the following prompt:
4. Click on the Browse button and select the ControlNet Project file created
in RSNetWorx for ControlNet (e.g., “Sched_PLC_to_Logix5550”).
5. Set the ControlNet Node to 11.
6. Click on OK.
In this field Select
Processor Name PRODUCER
Platform ControlNet
Processor (Enter your processor type)
Series
(Enter your processor’s series)
(1)
(1)
F series is recommended but not required.
Revision (Enter revision letter)
Driver AB_KTC-1
Processor Node 11

Allen-Bradley ControlLogix Specifications

General

Communication	EtherNet/IP, ControlNet, DeviceNet, DH+
I/O Capacity	Up to 128, 000 I/O points (varies by configuration)
Redundancy	Supported (with specific modules)
Programming Software	Rockwell Automation Studio 5000 Logix Designer
Operating Temperature	0°C to 60°C (32°F to 140°F)
Programming Languages	Ladder Logic, Function Block Diagram, Structured Text, Sequential Function Chart
Modularity	Yes
Certifications	UL, CE
Processor Type	Multiple options available, including standard, safety, and extreme environment processors
Power Supply	Multiple options available, including standard and redundant power supplies with various voltage ranges (e.g., 24V DC, 120/240V AC)