Allen-Bradley ControlLogix User Manual

1756-6.5.3 - December 1999
9-6 PLC-5C to PLC-5C Unscheduled Messaging Over Two ControlNet Networks
You will see a window similar to the following one.
5. Click on Ye s to download the program.
• It is not necessary to keep the existing Online ControlNet
configuration.
6. Go Online and put the processor in Run mode.
7. Minimize RSlogix5.
Test the Example Application
Perform the following steps to test the example application:
1. Start another session of RSLogix5.
2. From the Comms menu in RSLogix5 select System Comms.
The System Options window will appear with the System
Communications tab open.
Verify that the
AB_KTC-1 driver is
selected.
Verify that the Reply Timeout is
set to a minimum of 10 seconds.

Allen-Bradley ControlLogix Specifications

General

Communication	EtherNet/IP, ControlNet, DeviceNet, DH+
I/O Capacity	Up to 128, 000 I/O points (varies by configuration)
Redundancy	Supported (with specific modules)
Programming Software	Rockwell Automation Studio 5000 Logix Designer
Operating Temperature	0°C to 60°C (32°F to 140°F)
Programming Languages	Ladder Logic, Function Block Diagram, Structured Text, Sequential Function Chart
Modularity	Yes
Certifications	UL, CE
Processor Type	Multiple options available, including standard, safety, and extreme environment processors
Power Supply	Multiple options available, including standard and redundant power supplies with various voltage ranges (e.g., 24V DC, 120/240V AC)