5-16 DVB-T/H Signal Analyzer Verification, Options 64 and 57 Option Verification
5-88 PN: 10580-00255 Rev. J MT8212E and MT8213E MM
4. On the MP8931A, press the Menu key.
5. Press the Down Arrow key until the triangle pointer is at System* on the display.
6. Press the Right Arrow key so that Initialize appears in the display.
7. Press the Enter key twice.
8. Pres the Menu key and then the Up Arrow or Down Arrow key until the triangle pointer is at Pattern.
9. Press the Enter key to select.
10. Press the Up Arrow or Down Arrow key until the triangle pointer is at ALL0 and then press the Enter
key.
11. Press the Down Arrow key. The pointer should be at Interface. Then press Enter to select.
12. Press the Right Arrow key and then press the Down Arrow key until the pointer is at DVB-ASI. Press the
Enter key to select.
13. Press the Menu key and then the Up Arrow or Down Arrow key until the triangle pointer is at DVB-ASI*.
Press the Right Arrow key and confirm that the PKT is set to (1) + 187 + (16).
14. On the MG3700A, press the yellow Preset key located on the upper-left side of the instrument.
15. Press the Down Arrow key to select Yes .
16. Press the Set key (Note that two
Set keys are available, and they both do the same thing).
17. Set the MG3700A Frequency to 470 MHz.
18. Press the Baseband key.
19. Press the More key, located at the bottom of the row.
20. Press the F5 Pattern Combination soft key as required until Edit appears.
21. Press the More key.
22. Press the F3 soft key so that Output B appears.
23. Press the Baseband key and then the F1 soft key.
24. Press the F2 soft key so that Memory A is highlighted.
25. Press the F1 key and use the Down Arrow key to highlight MS8911B-057_Inspection.
26. Press the Set key.
27. Use the Arrow key to highlight 8M_AWGNand press the Set key. If an Overwrite question appears, then
answer Yes.
28. Press the F2 soft key so that Memory B is highlighted
29. Highlight 8M_8k_64QAM_2_3_ALL0 and press the Set key. If an Overwrite question appears, then
answer Yes.
30. Press the F6 (Return) soft key.
31. Use the Arrow keys to highlight the blank line between Pattern:[ and the small green A memory symbol.
32. Press the Set key.
33. Ensure that MS8911B-057_Inspection is highlighted, and press the Set key.
34. Ensure that 8M_AWGN is highlighted, and press the Set key.
35. Use the Arrow keys to highlight the blank line between Pattern:[ and the small violet B memory symbol.
36. Press the Set key.
37. Ensure that MS8911B-057_Inspection is highlighted and press the Set key.
38. Ensure that 8M_8k_64QAM_2_3_ALL0 is highlighted and press the Set key.
39. Use the Arrow keys to highlight the Frequency Offset and enter 4MHz.
To Next Page
Loading...
