CPS100 SERIES OPERATION MANUAL
SECTION 6:
Front Panel Operation
Entire Contents Copyright 2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual Page 140 of 231
Running the IEC 4-28 test
Return to the previous IEC 4-28 menu by
pressing the [Esc] key.
Press the Trigger soft key to apply the test to
the unit under test. Once pressed, it changes
to Stop.
The test will now run until completed. Total
test time is determined by the Class settings.
The test time count down in seconds is
visible in the upper part of the IEC 4-28
screen.
At the completion of the test, the Stop soft
key will revert to Trigger. To abort a test in
progress, press the Stop soft key during a
test run.
To Next Page
Loading...