CPS100 SERIES OPERATION MANUAL
SECTION 8:
Master Slave Operation
Entire Contents Copyright 2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual Page 187 of 231
Multi-Unit Programming Instructions
Some front panel operations and menu operate differently when using multi-unit
configurations. The table below provides and overview of the key differences between
stand-alone mode (1 unit only) and any of the available multi-unit configurations.
Output
& More
Waveform Yes, Slaves in sync with the master unit
Yes, Slaves in sync with the master unit
Applies to phase A
only. Phase B &C will
be shifted 120° & 240°
Yes, Slaves in sync with the master unit
1
Yes, Slaves in sync with the master unit
Yes, Slaves in sync with the master unit
Yes, Slaves in sync with the master unit
Waveform
Preview
Yes but only Master unit can display
Zo Program Not supported
Measure Setting
Yes, Slaves in sync with the master unit
Yes, Slaves in sync with the master unit
Config
Yes, Slaves in sync with the master unit
Output Mode
Special Function Yes Yes Not supported
Table 8-1: Multi-Unit Programming Summary
Footnotes:
1. Soft Start includes Vac S/R, Vdc S/R and F S/R settings
2. O/P Relay function set as ON only available in single mode.
3. Calibration function only only available in single mode.
4. Harmonics function only available for the master unit.
5. Only IEC 61000-4-11 available for the 3-phase system.
To Next Page
Loading...