APS CPS100 Series - Unpacking CPS130, CPS140 and CPS150 Models

To Next Page

To Previous Page

CPS100 SERIES OPERATION MANUAL

SECTION 5:

Unpacking and Installation

APS CPS100 Series Power Source Operation Manual Page 42 of 231

7. Remove the top foam insert piece and retain for future use if desired.

8. Removal:

a. Stand as close to the back of the box (where the rear panel of the unit is)

and bend with your knees.

b. Get a firm handhold underneath the units by placing your hands on each

side of the unit near the middle. This will help even the weight when lifting.

c. While keeping your back straight, lift the unit out of the box by straightening

your legs.

d. Place the unit on the intended staging surface, usually a bench or table.

5.2.2 Unpacking CPS130, CPS140 and CPS150 Models

WARNING

THESE CPS MODELS WEIGH 29 Kg / 63.9 lbs. OR MORE.

AT LEAST TWO PEOPLE ARE REQUIRED TO LIFT AND HANDLE

All 4U tall CPS100 Series models are shipped in a cardboard box with protective foam

inserts. To remove these units, two persons are required due to weight.

Removal Steps:

1. Position the carton on a stable flat surface with sufficient clearance.

2. Know where the unit will be placed before proceeding. Make sure the path between

the carton and the staging area is short and clear of any obstacles.

3. Use a box cutter to cut the tape that holds the top flaps together. Also cut the side

tape on the top flaps.

4. Open all four flaps completely and fold them down along the side of the carton so

they do not interfere with access to the inside of the carton.

5. Remove the ship kit items from the box and put in a safe place.

6. Remove the top foam insert piece and retain for future use if desired.

7. Removal:

a. Two people are required depending no model/weight.

b. Have each person stand as close to the front and the back of the pallet and

bend with your knees.