CPS100 SERIES OPERATION MANUAL
SECTION 7:
Remote Control Programming
Entire Contents Copyright 2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual Page 155 of 231
Status Commands
Status commands are used to determine the state of the power source report on any error
conditions or faults.
Command Description
ASWRS? Returns last error code
ASWRC_0 This command clears all error codes. Also removes Fault pop-ups displayed
on LCD screen.
Table 7-4: Status Commands
Refer to tables below for a listing of all error codes for either Stand-alone mode or multi-
unit Master / Slave mode of operation.
Inner Under Voltage Protection
Inner Over Voltage Protection
Reverse Current Protection
Over Temperature Protection
Input frequency BNC input > 1.2kHz
Over Range mA current range
Over Range low current range
Primary Over Current Protection
Primary Over Temperature Protection
Primary Under Voltage Protection
Table 7-5: Error Codes - Stand-alone Mode
Modes for Master/Slave don’t match
Model numbers are not the same
Missing Phase Slave unit B
Missing Phase Slave unit C
More than one Master unit in system
More than one Slave with same number
Table 7-6: Error Codes –Master / Slave Mode
To Next Page
Loading...