APS CPS100 Series - Product Features; Standard Versus Enhanced Versions

CPS100 SERIES OPERATION MANUAL
SECTION 3: PRODUCT OVERVIEW
Entire Contents Copyright  2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual Page 18 of 231
Product Features
The following key characteristics apply to all CPS100 Series models:
• Fully programmable AC and DC output modes
• Frequency range in AC mode is 15 Hz to 1000 Hz (Standard “S”version) or 15 Hz to
1200 Hz (Enhanced “E” version)
• Dual voltage ranges in both modes
• AC voltage ranges are 0-150Vac and 0-300Vac RMS
• DC voltage ranges are 0-212Vdc and 0-424Vdc.
• Programmable Current limit with Fold-Back (CC) and Shutoff Modes (CV)
• Full complement of output parameter metering:
o Frequency
o Volt AC or DC
o Current AC or DC
o AC Peak Current
o Current Crest Factor
o True Power
o Apparent Power
o Power Factor
• Over voltage, over current, over power and over temperature protection
• Fan Cooled
• RS232, RS488, USB, LAN and GPIB remote control interfaces
• Remote Interlock
Standard versus Enhanced Versions
The CPS100 Series is available in one of two versions, Standard (S Suffix) or Enhanced (E
Suffix). The version is identified in the model number by either an S or an E at the end of the
model. Standard versions cannot be upgraded to Enhanced versions due to hardware and
firmware differences so desired version must be specified at time of order.
The table below highlights the differences between the two versions.
FEATURES VERSION:
STANDARD
ENHANCED
AC Mode


DC Mode


AC+DC Mode


Frequency Range
15-1000Hz
15-1200Hz
Dual AC Voltage Ranges 150/300 Vac


Dual DC Voltage Ranges 212/425 Vdc


Harmonic Waveforms Library (fixed)


Waveform Synthesis from Front Panel


Transient List Mode


Measurements


Harmonic Waveform Synthesis

Harmonic Analysis & THD Measurements

Programmable Impedance

IEC411


IEC413
