APS CPS100 Series - Table 7-17: Master; Slave Configuration Commands

CPS100 SERIES OPERATION MANUAL
SECTION 7:
Remote Control Programming
Entire Contents Copyright  2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual Page 172 of 231
Command Description
PARA:SLAVEA:ALL?
This command queries all measurement parameters from Slave A.
Returns a comma-delimited string.
PARA:SLAVEB:VOLT?
This command queries the measurement of the slave 2 output voltage
in volts RMS.
PARA:SLAVEB:CURR?
This command queries the measurement of the slave 2 output current
in amperes RMS.
PARA:SLAVEB:POWER?
This command queries the measurement of the slave 2 output power in
Watts (W).
PARA:SLAVEB:VDC?
This command queries the measurement of DC component of the slave
2 output in volts.
PARA:SLAVEB:ALL?
This command queries all measurement parameters from Slave B.
Returns a comma-delimited string.
PARA:SLAVEC:VOLT?
This command queries the measurement of the slave 3 output voltage
in volts RMS.
PARA:SLAVEC:CURR?
This command queries the measurement of the slave 3 output current
in amperes RMS.
PARA:SLAVEC:POWER?
This command queries the measurement of the slave 3 output power in
Watts (W).
PARA:SLAVEC:VDC?
This command queries the measurement of DC component of the slave
3 output in volts.
PARA:SLAVEC:ALL?
This command queries all measurement parameters from Slave C.
Returns a comma-delimited string.
Table 7-17: Master / Slave Configuration Commands