EasyManuals Logo

Austro Engine AE330 User Manual

Default Icon
360 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #280 background imageLoading...
Page #280 background image
Maintenance Manual
E4.08.04
Issue date: 14-Apr-2015
Page: 85-28
Revision no: 25
For further operation of the Two-Mass Flywheel the ring has to be reworked. Use a sharp knife to cut
off the ragged area of the ring. If the width of the ring is less than 50% or the ring gets broken, the
Two-Mass-Flywheel has to be replaced.
Fig. 85 - 44
Thereafter reposition the ring. Therefore lift the secondary mass slightly thus the ring can be
repositioned with a small screwdriver.The correct position is reached when the inner diameter of the
ring has approximately the same gap to the outside diameter of the notch in the primary mass as
demonstrated with the green dotted line in Fig. 85 - 42.
Pick-up ring:
If the teeth of the pick-up ring are out of shape the engine run could be rough. Therefore if the teeth
are bent the two-mass-flywheel has to be replaced.
Fig. 85 - 45
>0,5*t
t

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Austro Engine AE330 and is the answer not in the manual?

Austro Engine AE330 Specifications

General IconGeneral
BrandAustro Engine
ModelAE330
CategoryEngine
LanguageEnglish

Related product manuals