Ayyeka Wavelet - LED Light Status Indicators; Leds Status Indications

www.ayyeka.com | +1 (310) 876-8040 | info@ayyeka.com 127
LED Light Status Indicators
The LEDs on the Wavelet's interface board provide indications of the device's status.
LEDs Status Indications
LEDs Status
Interpretation
All LED are off
Not connected to network. The LED lights do not blink when the device
is sampling.
Note: Wavelet may be powered down (power switch is in the OFF
position), in Hibernate mode, or have insufficient battery power.
Green LED is blinking
Attempting to connect to network.
Green LED remains on
Transmission of data is in progress; the LED will turn off when
transmission is complete.
Green and Red LEDs blink 5x
Communication error. The device failed to transmit.
Red and Blue LEDs blink 5x
Sensor error.
Green-Red-Blue-Red-Green
LEDs blink sequentially 5x
Wavelet activated using Magnetic Activator. This is typically followed by
firmware boot sequence.
Green, Red, Blue LEDs blink 5x
Bootloader is starting up when the device powers up. This is typically
followed by firmware boot sequence.
Green and Blue LEDs blink 2x,
then Red
Firmware is booting.
Blue LED is blinking
Bootloader is active, not connected to the network.
Blue and Green LEDs are
blinking
Bootloader is active, trying to connect to network.
Blue LED is blinking, Green LED
is constantly ON
Bootloader is active, upgrading firmware.