www.ayyeka.com | +1 (310) 876-8040 | info@ayyeka.com 126
TROUBLESHOOTING
Wavelet device does not turn on
Problem: Magnetic activator does not turn the Wavelet on
Recommended Actions:
1. Partially unscrew the six (6) screws located on the back of the Wavelet enclosure (see Battery
Replacement Instructions, step 2), until you can lift off the back panel with the screws still affixed to their
screw holes.
2. Remove the Wavelet’s back panel and place it flat-side down adjacent to the Wavelet box.
3. On the interface board, move the ON/OFF switch to the ON position (see Battery Replacement
Instructions, step 4).
The Wavelet device turns on and performs a 10-minute calibration process, after which it starts
operating in normal mode
4. Replace the Wavelet back panel, ensuring that the battery cable is neatly arranged and not pinched
within the Wavelet enclosure.
5. Tighten the six (6) back panel screws until the Wavelet is closed and sealed. Do not over-tighten as this
will strip the screw threads.
To Next Page
Loading...