www.ayyeka.com | +1 (310) 876-8040 | info@ayyeka.com 28
Aggregation Report
The Aggregation report enables viewing a statistical analysis of the readings obtained in one or more data streams
of a specific type.
To create an Aggregation report:
1. Click Reports in the side bar.
2. In the Aggregation Report pane:
a. Select whether to specify streams By Site or By Stream Type.
b. If you selected to specify streams By Site, specify the site, and then specify stream(s) in the site.
c. If you selected to specify streams By Stream Type, specify the stream type, and then specify
stream(s) of that type.
d. Specify the reporting Time Period.
3. Select the aggregation period - from 1 min intervals to 1 month intervals.
4. If you select to run the report for multiple streams, you can:
a. Select which statistical analysis function to run on those streams: either Sum, Average, Min, Max or
Standard Deviation
b. Specify Separate Streams if you wish to run a separate analysis for each of the specified streams.
For example, if you had specified Stream1 and Stream2 and chosen Average, then:
Choosing Separate Streams will provide the average of all Stream1 recorded values in one
column, and the average of all Stream2 recorded values in a second column.
Not choosing Separate Streams will provided an average of all Stream1 and Stream2 recorded
values, in a single column.
Note that you can generate an Aggregation report for multiple streams only if all those streams are of
the same type (such as Level), and use the same unit of measurement (such as inches).
To Next Page
Loading...