EasyManua.ls Logo

Azbil DCP31 - Page 130

Azbil DCP31
242 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-20
Chapter 7. PARAMETER SETUP
•TheMFBdisconnectedalarmdoesnotoccur.
•TheerrorbetweenactualmotorvalveopeningandestimatedMFB
valueiscompensatedbyforciblycontinuingmotoroperationin
theclosedoropendirectionswhenMVis0.0%and100%.
.-A
t
(motor valve opening automatic adjustment)
0: Adjustmentdisabled
1: Adjustmentenabled
Thisparameterautomaticallymeasuresthemotorfullyclosed
position,fullyopenposition,andclose-opentimes.Theresultsof
calculationareautomaticallywrittento
.-C L
,
.-O P
and
.-t
.
•AdjustmentMethodandMotorFunctions
1. Set
.-C
to0or1.
2. Set
.-A t
to1,andpress
ENT
.
Ifsetto1already,press
ENT
twicetoenterautomaticadjust-
ment.
3. Automaticadjustmentiscarriedout.
-
C A .C L
isdisplayedontheupperdisplay,andtheclosed-side
relayturnsON.
- Themotoroperatestotheclosedside,andtheMFBcount
valueisdisplayedonthelowerdisplay.Whenthecounthas
stabilized,fullyclosedadjustmentiscompleted,andthe
countvalueiswrittento
.-C L
.
-
C A .O P
isdisplayedontheupperdisplay,andtheclosed-
siderelayturnsON.
- Themotoroperatestotheopenside,andtheMFBcount
valueisdisplayedonthelowerdisplay.Whenthecounthas
stabilized,fullyopenadjustmentiscompleted,andthecount
valueiswrittento
.-O P
.
Thetimeittookfromfullyclosedtofullyopeniswrittento
.-t
.However,notethatifthistimeis240.0sormore,the
timeistakenas240.0s.
- Whenalladjustmentsarecompleted,thecontrollerreturns
tothebasicdisplaystate.
4. Tocancelautomaticadjustment,press
DISP
.
Whenautomaticadjustmentbegins,youcannotpressanykeys
otherthan
DISP
.
DISP
isusedforcancelingadjustment.
Thefollowinginstancesareregardedaserrors.Inthesein-
stances,thefactorysettingsarereturnedto,and
A L 1 2
is
displayed.The
A L 1 2
displaycanbeclearedonlywhenauto-

Table of Contents

Related product manuals