Azbil DCP31 - Page 145

7-35
Chapter 7. PARAMETER SETUP
No. Item Code Item
Factory
Setting
User
Setting
Setting
30
E d . t 4
T4 event standby 0 0: Standby OFF
1: Standby ON
[Note]
The controller stands by after power
is restored and in the READY mode.
When the event type setting is ≥ 50,
“– – – –” is displayed and setting is not
possible.
31
H y . t 4
T4 event hysteresis 5 0 to 200U (when event type is neither MV
nor MFB)
0.0 to 20.0% (when event type is MV or
MFB)
[Note]
When the event type setting is ≥ 50,
“– – – –” is displayed and setting is not
possible.
32
d l . t 4
T4 event ON delay
time
0 0 to 3600s