Azbil DCP31 - Page 216

9-16
Chapter 9. MAINTENANCE & TROUBLESHOOTING
(5) Pullthebodyouttowardsyoutoremovefromthecase.
>>Youshouldbeabletoseethebutton-shapedbatteryonthe
leftfacingthebody.
(6) Placethebodyonitssaveonadeskorflatsurfacesothatthe
sideonwhichthebatteryisinstalledisfacingup.
(7) Removethebatteryfromitsgrayholder.
(8) RemovetheRAMboard(approx.3cm×8cm)withthebattery
stillconnectedtotheboard.
TheRAMboardisconnectedtothebaseboardbytwoconnectors.
Handling Precautions
• When placing the RAM board on the desk, make sure that
the solder surface of the board is face down. If the compo-
nent mounting surface is placed face down, the components
may become damaged.
(9) RemovethebatteryconnectorfromtheRAMboard.
Battery
Connector
Connector
RAM board
(approx. 3 cm x 8 cm)