Azbil DCP31 - Page 217

9-17
Chapter 9. MAINTENANCE & TROUBLESHOOTING
(10)Connecttheconnectorofthenewbattery
totheRAMboardmakingsurethatitis
insertedthecorrectdirection.
(11)MounttheRAMBoardmakingsurethat
itismountedinthecorrectdirection.Run
thebatterycablesoverorundertheRAM
board,payingattentiontothefollowing
points.
If the cables arerunover the
RAM board, be sure not to
pinch the battery cables with
thecasewhenputtingthecon-
trollerbackintothecase.
Ifthecablesarerununderthe
RAM board, be sure not to
pinch the battery cables with
theconnector.
(12) Fitthebatteryintothegrayholdersothatthebatterycableis
abovetheRAMboard.
(13) Insertthebodyintothecase.
Donotexertexcessiveforceifthebodycannoteasilyfitinto
thecase.Also,makesurethattheboardsmountedonthebody
arenotlooseortwisted.
Connector
Gray holder