118
Technical data • Entire device
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
49 "System unit revisions for at least 10 seconds turn-off time" might not restart because a
Power Off/On was not detected. To make sure that these system units will restart after a Power
Off/On, the turn-off time should be set to at least 10 seconds.
Thanks to a workaround, the turn-off time can be set as needed in systems with one of the
following system unit revisions or higher.
Model number Description Revision
5PC600.SX01-00 System 1 PCI Starting with revision B0
5PC600.SX02-00 System 2 PCI, 1 disk drive slot, 1 AP Link slot Starting with revision B0
5PC600.SX02-01 System 2 PCI, 1 disk drive slot Starting with revision B0
5PC600.SX05-00 System 5 PCI, 2 disk drive slots, 1 AP Link slot Starting with revision A0
5PC600.SX05-01 System 5 PCI, 2 disk drive slots Starting with revision A0
Table 49: System unit revisions for at least 10 seconds turn-off time
Model number Description Revision
5PC600.SX01-00 System 1 PCI Starting with F0
5PC600.SX02-00 System 2 PCI, 1 disk drive slot, 1 AP Link slot Starting with revision E0
5PC600.SX02-01 System 2 PCI, 1 disk drive slot Starting with F0
5PC600.SF03-00 System 3 PCI, 1 disk drive slot, 1 AP Link slot Starting with revision A0
5PC600.SX05-00 System 5 PCI, 2 disk drive slots, 1 AP Link slot Starting with revision D0
5PC600.SX05-01 System 5 PCI, 2 disk drive slots Starting with revision D0
Table 50: System unit revisions for any turn-off times
To Next Page
Loading...
