B&R Automation PC 620 - Page 122

122
Technical data • Entire device
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
The cable types and resolutions shown with a footnote 2) in the previous table can only be
implemented starting with the following firmware and hardware versions:
Firmware Name Version Note
MTCX FPGA Firmware on the APC620 v 01.15 The version is read from BIOS - see the
BIOS description.
Supported starting with the APC620 /
PPC 700 Firmware upgrade (MTCX,
SDLR, SDLT) V01.10, available in the
download area of the B&R homepage.
MTCX PX32 Firmware on the APC620 v 01.55
SDLR FPGA Firmware on the AP Link SDL receiver and
transceiver
v 01.04
SDLT FPGA Firmware on the AP Link SDL transmitter v 00.02
Hardware Name Revision Note
5DLSDL.1000-00 AP Link SDL receiver Rev. D0
5DLSDL.1000-01 AP Link SDL transceiver Rev. D0
5AC600.SDL0-00 AP Link SDL transmitter Rev. B3
5PC600.SX01-00 System 1 PCI Rev. E0
5PC600.SX02-00 System 2 PCI, 1 disk drive slot, 1 AP Link slot Rev. D0
5PC600.SX02-01 System 2 PCI, 1 disk drive slot Rev. E0
5PC600.SF03-00 System 3 PCI, 1 disk drive slot, 1 AP Link slot Rev. A0
5PC600.SX05-00 System 5 PCI, 2 disk drive slots, 1 AP Link slot Rev. C0
5PC600.SX05-01 System 5 PCI, 2 disk drive slots Rev. C0
Table 54: Requirements for SDL cable with extender and automatic cable adjustment (equalizer)