To Next Page

To Previous Page

R5906848 /04 DP2K SLP Series324

Code 5641: “light source - light is on, but SMPS is off” (Error)

Situation Solution

This error alone, or with other

SMPS errors: Malfunction

SMPS module

Replace the SMPS module. See “Switch Mode Power Supply (SMPS)”,

page 39.

This error alone: Defect Signal

Backplane

Replace the Signal Backplane. See “Card Cage”, page 209.

In combination with other

errors

Check the projector log files for other listed errors and solve these errors

first.

Code 5646: “light source - Switching on the light source failed” (Error)

Situation Solution

The light source goes out

immediately after powering it,

or does not go on at all.

Check the projector log files for other listed errors and solve these errors

first.

Code 5647: “light source - The light source was switched off due to an error” (Error)

Situation Solution

The light source was triggered

to switch off the lasers due to

an error.

Check the projector log files for other listed errors and solve these errors

first.

Code 5800: “TI-boards - system status = fail”

This is a generic TI error. Use the Communicator to make a detailed analysis. Go to Diagnostics > Actual >

Cinema Front End Status > Detailed status > Error Messages. Possible error messages are:

Situation Solution

Malfunction software. Reboot the projector.

ICP board is not correctly

seated.

Reseat the ICP board. See service manual chapter “Replacement of the

ICP board”, page 214.

ICP self test - ICP frame

memory test failed