R5906848 /04 DP2K SLP Series 391
Image 26-13
2. Clean the Prism inlet according the general cleaning procedure for optical parts, see “General cleaning
procedure for optical components”, page 384.
Image 26-14
3. Clean the Prism outlet according the general cleaning procedure for optical parts, see “General cleaning
procedure for optical components”, page 384.
Image 26-15
4. Install the Light Processor. See “Installing the Light Processor”, page 100.
Projection lens inlet
1. Remove the lens from the projector, if not removed yet. See “Lens removal”, page 178.
2. Follow the general cleaning procedure for optical parts to clean the lens inlet, see “General cleaning
procedure for optical components”, page 384, or see “Cleaning the lens”, page 292.
3. Install the lens. See “Lens installation”, page 176.
Projection lens outlet
1. Follow the general cleaning procedure for optical parts to clean the lens outlet, see “General cleaning
procedure for optical components”, page 384, or see “Cleaning the lens”, page 292.
Porthole
1. Follow the general cleaning procedure for optical parts, see “General cleaning procedure for optical
components”, page 384.
Tip: Ensure to clean both sides (booth side and audience side) of the Porthole.
Projector cleaning
To Next Page
Loading...
