Bentel Security FireClass 200 - Upgraded;New Technical Features (Firmware Version 4.00)

Upgraded/New technical features (Firmware version 4.00)
r Extended template provides full alarm details (refer to the Operator’s Man-
ual ---- pages 9, 10)
r RS485 protocol upgrade for fast data transmission
r Centralized Master panel Log ---- retrieves, saves and broadcasts all the
network events (refer to the Operator’s Manual pages 9, 10)- Logger on
Slave: (refer to the Software Manual "System")
r View Alarm event details from Repeaters (refer to the Operator’s Manual
---- pages 9, 10)
r New "Ignore output supervision" option for dry-contact management of
Output Modules (refer to Installation Manual page 48)
r New Single Zone/ALL Zone Double knock option (refer to the Installer’s
Manual ---- pages 48, 49)
r New Zone Prealarm event (refer to the Installer’s Manual ---- pages 47, 48,
49)
r Resets slave panel from master (refer to the Software Manual "System")
r Resets master panel from slave (refer to the Software Manual "System")
r Sets to Day Mode on power up (at default)
r Verify Alarm option (refer to the Installer’s Manual ---- page 44, 45 and Op-
erator’s Manual ---- pages 18, 25).
r Manages Prealarms (refer to the Installer’s Manual ---- page 58 and Opera-
tor’s Manual ---- pages 9, 13).
r Manages Warning signals (refer to the Installer’s Manual ---- pages 47, 48,
53, 59, 75)
+
FireClass control panel firmware verions 4.00 and Repeater firmware ver-
sions 1.2 CANNOT operate on applications using FireClass control panels
and Repeaters with lower firmware versions.
10 Analogue Fire Control Panel FireClass200