Print
The Print option from the READINGS menu prints all the log contents on
the connected printer.
1. Select the Print option from the READ-
INGS menu (press 5) or press ESC to step
back to the MAIN menu.
2. Select the Log option (press 1) or press
ESC to step back the READINGS menu.
3.
Press the ↵ key to start the Log printout or
press ESC to exit and step back to 2.
4. The display will show ...
+
The control panel will continue functioning during the log printout.
Printer not
enabled
The printer must be enabled, otherwise, at
step 4. the display will show ...
Printer not
connected
The serial printer must be connected to the serial port of the control panel.
The control panel will not signal Printer not connected and/or Printer not
ready (paper out, no ink or blocked etc.) conditions.
Stop Print To stop Print - proceed as per start Print.
At step 3. press ↵, the display will show ...
READINGS:
1=Dev./Zones/Outputs
2=Opt.3=Ver.4=Log.
5=Print 6=M.Telecom
READINGS
Print:
1= Log 2=
Programming
Log Print Sta
rt Print ? Ent
er = Yes Esc
= Exit
Log Print
running
please
wait....
Printer not
enabled !
Enable in
menu’ PRG:SYSTEM
Log Print
running
SUSPEND ?
Yes = Enter
READING PARAMETER 91
To Next Page
Loading...
